the Essential Steps in the Process of Mounting a License Plate
It is illegal to drive without a license plate as you are said to be committing a crime. When you are seen driving without a license plate by the police, you become their next target. Your car should, therefore, have a license plate attached to it. Therefore, you must know how to mount a license plate. The first step is to gather all the tools that you will need. The tools are; a flat-headed screwdriver, the right screws and the validation sticker.
The next step varies with whether it the first time to install a license plate in your car or it has ever been installed with one. Drilling other holes is unnecessary when your car had earlier on been mounted license plates. If you are still using the expired license plates, you remove them and clean the place in preparation to attach the new validation tag. A screwdriver may be of use when you are prying off the old sticker. You stick the validation tag at the top corners of your license plate. In an already drilled car, you just should line up the plate with the existing holes and screw it using a screwdriver. You should ensure that the plate is not that tight. When mounting the license plate for the first time, it becomes essential to drill holes. You should make sure that your bumper is made of fiberglass. Using a pen, you mark the center of your bumper after measuring it with a tape. Hold the license plate at the area to mark where you should drill the holes. You drill shallow holes and repeat the procedure of already predrilled holes.
There is also an alternative for those who are not ready to drill holes in their bumper. You buy an adhesive-mounted bracket that fits the make and model of your car. It is advisable to clean up the area with rubbing alcohol to ensure that the adhesive sticks properly. After the bumper has dried, you try fitting the bracket with its protective film on. After fitting, you peel off the protective film at the back of the bracket and place it onto the bumper. You attach the license plate to the bracket and screw it with a screwdriver. It is advisable for people whose cars are made of metal and have never drilled holes to use this method. It is hard to drill in a metal bumper, and that is why it is advisable to use the method.
More info about how to install a license plate can be obtained online.